Warning for charging your battery and welding with POINT

Battery Charging and Welding Warning

WARNING!


Battery Charging

Always disconnect your POINT device from your battery when charging your battery on your tractor or implement.  Failure to disconnect the battery from the POINT device can result in serious damage to the indicator.  This damage is not covered under the manufacturer limited warranty.


Welding on Equipment


It is suggested that you disconnect and remove your POINT scale device when welding on your equipment.  Failure to remove your POINT scale device may  result in serious damage to the indicator.  This damage is not covered under the manufacturer limited warranty. 



    • Related Articles

    • Ordering POINT for Livestock Scales

      Ordering POINT for Livestock Scales Answer the questions below to determine which conversion kit is necessary to add a POINT scale to your livestock chute. 1) Does the chute already have a scale? Yes (proceed to question 2A) No ​(Kit - 7300137RI & ...

    • Compatibility: Apple Devices that Will Support POINT

      Apple Hardware Compatibility POINT is iOS 9.0 compatible.  POINT will support the Apple operating system called iOS from 9.0 and newer.   Below are lists of Apple hardware and some specific comments about use of these devices with the POINT ...

    • Using POINT to Evenly Fill Multiple Hoppers on a Drill or Planter

      Using POINT to Evenly Fill Multiple Hoppers on a Drill or Planter Start with all hoppers empty and the POINT in gross mode. Zero the scale by pressing "ZERO" in the app or the furthest right button on the POINT (It looks like a O with a / through ...

    • Zero Balance POINT

      Zeroing POINT You can operate POINT from the keypad or the mobile device.   To Zero Point from the Keypad.... 1.  Press and hold the Zero Button on the right side of the keypad for three seconds.  A countdown will display until zero. NOTE:  We ...

    • POINT Quick Start Guide

      Quick Start Guide Use this Quick Start Guide to help you get set up and running immediately.  Refer to the help center for additional instructions and answers to questions..... Lets get started. Package Contents (Inside the box) Tools Required ...