Changing the Setup and Cal Numbers on SW300 and SW600
Related Articles
Changing Setup and Calibration Numbers in a Digi-Star Indicator
Changing Setup and Calibration Numbers in a Digi-Star Indicator 1. Hold the ZERO button and the ON button until "SETUP" is shown on the screen. 2. After "SETUP" the indicator will display its current setup number with the last digit flashing. A good ...Avery Weigh-Tronix Load Cell Calibration Numbers
The reading @ 0.4mV/V can be used as the Calibration number for a Digi-star indicator, or the Custom number on a Weigh-tronix indicator.Chute Calibration Numbers
See the attached document for chute calibrations including Tru-Test and Gallagher.Changing Config Number in Model 640
Press and hold the "Hold/Menu" button for three beeps then release. Enter "640". Use "RM" to increase the displayed value and "M+" to decrease it. Press the "Hold/Menu" button to move one digit to the left. Press "Print/Select" to accept and "640" ...GT460, Unverferth 510, 512, 520 Calibration
Watch the video to calibrate your Indicator