John Deere Display update 25.1 (Implement Setup for Planter Scales)

John Deere Display update 25.1 (Implement Setup for Planter Scales)


After a Gen 4 or Gen 5 John Deere display has been updated to software version 25.1, the display may prompt the user to setup an implement profile for the scale.  For all non-harvest related scale systems, follow these steps.




Follow these steps.
1. Equipment Detected, Select NEXT
2. Select Equipment, Select OK
3. Implement Profile, DO NOT SELECT AN EQUIPMENT TYPE, Select Cancel
4. Equipment, Select OK

    • Related Articles

    • John Deere Grain Harvest Weight Sharing ( GHWS ) Setup

      Connecting to John Deere Grain Harvest Weight Sharing (GHWS) Mount POINT on the magnetic mounting bracket. Place POINT with the magnetic mount on the side or front of the grain cart. Connect the load cell cable to POINT. Connect the 8-pin end of the ...

    • Enable ISOBUS PTO and GPS Detection For Use With REAP

      POINT now allows both the detection of PTO status and GPS coordinates over ISOBUS. If a StarFire receiver is connected, POINT will use its position data to add Lat./Lon. coordinates to each load ticket that is recorded. To enable these features, ...

    • Firmware: Pushing an Update to Your POINT (iOS)

      FIRMWARE UPDATE We’ve sent an important firmware update to your POINT app. You can now push this update over the air (wirelessly) to your POINT device. We do this in order to maximize performance, stability and ease of use of your POINT device in ...

    • Firmware Feature Release POINT® Firmware 2.2.6 (GPS over ISOBUS)

      PRODUCT BULLETIN Last Update: 06/24/2024 - Nick Von Muenster REVA FIRMWARE FEATURE RELEASE POINT® FIRMWARE 2.2.6 (GPS over ISOBUS) Feature Highlight Available today, the POINT® scale indicator can now interact with NMEA GPS messaging formats over ...

    • POINT ISOBUS Troubleshooting

      Check to make certain that the cables are connected correctly. When connecting POINT to ISOBUS the power port on the far left should be empty. The ISOBUS harness that provides power and connects POINT to the tractor must be plugged into the DT8 port ...