Point Replacing OMNI Scale Head

When connecting a POINT to OMNI bars, the red J-box wire must go to the green bar wires, green to white, and white to red.  

• Related Articles

• Dual Scale Mode

  Enabling Dual Scale Mode To enable dual scale mode the POINT must be updated to firmware 2.1.12 or later Go to "Choose Mode" and select Dual Scale, then click Select. Configuring Dual Scales Calibration Weight, Scale Capacity, Display Count, and ...

• Using POINT to Evenly Fill Multiple Hoppers on a Drill or Planter

  Using POINT to Evenly Fill Multiple Hoppers on a Drill or Planter Start with all hoppers empty and the POINT in gross mode. Zero the scale by pressing "ZERO" in the app or the furthest right button on the POINT (It looks like a O with a / through ...

• Loading and Unloading -Tare- Your Scale with the POINT Keypad

  Tare Mode from the POINT keypad If you don't know what the Tare mode is, you are not alone.  Most people not well versed in the "scale" terminology don't understand what a Tare is.  In the easiest way possible to describe a tare, it allows you to ...

• Using the POINT App as a Remote Display (iOS)

  LIVE Scale Page POINT communicates via Bluetooth Wireless Long Range technology.  It has a 2500 Ft reception range and can be simultaneously connected to as many iPhones and iPads near by the POINT device.   This allows for multiple remote display ...

• Zero Balance POINT

  Zeroing POINT You can operate POINT from the keypad or the mobile device.   To Zero Point from the Keypad.... 1.  Press and hold the Zero Button on the right side of the keypad for three seconds.  A countdown will display until zero. NOTE:  We ...