Unverferth 520 Displays "INVALID" When Entering D.A.N.

Unverferth 520 Displays "INVALID" When Entering D.A.N.

In the past, all Unverferth 520 used the same settings and D.A.N. as the GT460.  Unverferth is now selling Unverferth 520 indicators that instead share settings and D.A.N. with the GT560.

  1. If the indicator says "AutoLog" on the face plate, it probably uses the GT460 settings.
  2. If the indicator has a port for a moisture sensor, it probably uses the GT560 settings.

    • Related Articles

    • Identifying Unverferth 520

      Identifying Unverferth 520 There are now two different versions of the Unverferth 520.  The old version shares settings with a GT460 while the new version is identical to a GT560.  Below are a few ways to identify a new Unverferth 520. P/N: 410510-U ...

    • Entering Long Form Settings in GT460, UNV510, UNV512, and UNV520

      Hold HELP then ON until the arrow disappears Press ZERO x 2 Press HELP x 2 Press SELECT x 3 Press HELP Press ZERO There should now be a 15 minute timer on the screen. Press ZERO x 5 Press HELP x 3 Press SELECT x 3 The Long Form Settings should now be ...

    • Digi-Star ERM Wi-Fi Settings

      ERM Wi-Fi Settings for Digi-Star Indicators If your Wi-Fi device is not working, please verify that these settings are correct. Option Setting changes using Direct Access Numbers (D.A.N.) for Digi-Star indicators with numeric Key Pads: Directly enter ...

    • Stock Weigh Settings

      Setting D.A.N. Description SW Default ZTRACK 104 Adjusts to zero for build-up of snow, mud and manure. Weight value can be set from 1 to 99 lbs/kgs or OFF (00) Weigh Method 5 W MTHD 105 Select weight method. LOCK LOCKON 106 Higher value will lock on ...

    • Using the Setpoint Feature on EZIII Indicators

      Using The Setpoint Feature on EZIII Indicators Setpoint is a feature that allows the operator to set a gross weight that will activate the +12VDC Relay Output on PIN 4 of the J901 power connector. This feature is commonly used for automations or ...