DT6 Connection
DT4 Pinout
Scale-Tec Point DT8 Connector
The Scale-Tec POINT system utilizes the 8 PIN connector (AT06-08SA-SR2BK) that supports the following interfaces: Serial (RS232) (COM1 and COM2) CANBus (ISOBUS) POWER 12v DC 3 Amp Digital I/O (AWT Base Connector Only) Below is the standard PINOUT for ...
DT6 Junction Bank Overview
We recommend routing your load cell and weigh bar connections through the DT6 junction bank, which comes standard with all of our scale kits. Bare wire connections and damaged or weathered junction boxes are common trouble areas in a scale system. A ...
7602586 - DT6 Single Plug Replacement
AT04 Connector Pin-Outs
AT04 connectors are used for POINT GPS ports and some POINT power ports. The pin-outs are shown below.
7601400 - Junction Bank Manual Rev A
Congratulations on the purchase of your new Scale-Tec DT06 Junction Bank. This Junction bank is designed to provide superior connection keeping dust and moisture out of the connection, as well as provide easy serviceability for troubleshooting ...